Dansk standard DS/EN 61290-10-1 1. udgave 2003-08-27 Optiske forstærkere Prøvningsmetoder Del 10-1: Flerkanalsparametre Impulsmetode, der anvender optisk afbryder og optisk spektrumanalysator Optical amplifiers Test methods Part 10-1: Multichannel parameters Pulse method using an optical switch and optical spectrum analyzer
DS/EN 61290-10-1 København DS projekt: 40599 ICS: 33.180.30 Deskriptorer: fiberoptik,måling,forstærkere,specifikation,lysledere,prøvning Første del af denne publikations betegnelse er: DS/EN, hvilket betyder, at det er en europæisk standard, der har status som dansk standard. Denne publikations overensstemmelse er: IDT med: IEC 61290-10-1:2003 og IDT med: EN 61290-10-1:2003. DS-publikationen er på engelsk. DS-publikationstyper Dansk Standard udgiver forskellige publikationstyper. Typen på denne publikation fremgår af forsiden. Der kan være tale om: Dansk standard standard, der er udarbejdet på nationalt niveau eller er baseret på et andet lands nationale standard, eller standard, der er udarbejdet på internationalt og/eller europæisk niveau og har fået status som dansk standard DS-information publikation, der er udarbejdet på nationalt niveau og ikke har opnået status som standard, eller publikation, der er udarbejdet på internationalt og/eller europæisk niveau og ikke har fået status som standard, fx en teknisk rapport, eller europæisk præstandard DS-håndbog samling af standarder, eventuelt suppleret med informativt materiale DS-hæfte publikation med informativt materiale Til disse publikationstyper kan endvidere udgives tillæg og rettelsesblade DS-publikationsform Publikationstyperne udgives i forskellig form som henholdsvis fuldtekstpublikation (publikationen er trykt i sin helhed) godkendelsesblad (publikationen leveres i kopi med et trykt DS-omslag) elektronisk (publikationen leveres på et elektronisk medie) DS-betegnelse Alle DS-publikationers betegnelse begynder med DS efterfulgt af et eller flere præfikser og et nr. fx DS 383, DS/EN 5414 osv. Hvis der efter nr. er angivet et A eller Cor, betyder det, enten at det er et tillæg eller et rettelsesblad til hovedstandarden, eller at det er indført i hovedstandarden. DS-betegnelse angives på forsiden. Overensstemmelse med anden publikation: Overensstemmelse kan enten være IDT, EQV, NEQ eller MOD IDT: Når publikationen er identisk med en given publikation. EQV: Når publikationen teknisk er i overensstemmelse med en given publikation, men præsentationen er ændret. NEQ: Når publikationen teknisk eller præsentationsmæssigt ikke er i overensstemmelse med en given standard, men udarbejdet på baggrund af denne. MOD: Når publikationen er modificeret i forhold til en given publikation.
EUROPEAN STANDARD EN 61290-10-1 NORME EUROPÉENNE EUROPÄISCHE NORM July 2003 ICS 33.180.30 English version Amplificateurs optiques - Méthodes d'essai Partie 10-1: Paramètres à canaux multiples - Méthode d'impulsion utilisant un interrupteur optique et un analyseur de spectre optique (CEI 61290-10-1:2003) Optical amplifiers - Test methods Part 10-1: Multichannel parameters - Pulse method using an optical switch and optical spectrum analyzer (IEC 61290-10-1:2003) Prüfverfahren für Lichtwellenleiter- Verstärker Teil 10-1: Mehrkanalparameter - Pulsmethode bei Verwendung eines optischen Schalters und optischen Spektralanalysators (IEC 61290-10-1:2003) This European Standard was approved by CENELEC on 2003-05-01. CENELEC members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the Central Secretariat or to any CENELEC member. This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CENELEC member into its own language and notified to the Central Secretariat has the same status as the official versions. CENELEC members are the national electrotechnical committees of Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Lithuania, Luxembourg, Malta, Netherlands, Norway, Portugal, Slovakia, Spain, Sweden, Switzerland and United Kingdom. CENELEC European Committee for Electrotechnical Standardization Comité Européen de Normalisation Electrotechnique Europäisches Komitee für Elektrotechnische Normung Central Secretariat: rue de Stassart 35, B - 1050 Brussels 2003 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members. Ref. No. EN 61290-10-1:2003 E
EN 61290-10-1:2003-2 - Foreword The text of document 86C/498/FDIS, future edition 1 of IEC 61290-10-1, prepared by SC 86C, Fibre optic systems and active devices, of IEC TC 86, Fibre optics, was submitted to the IEC-CENELEC parallel vote and was approved by CENELEC as EN 61290-10-1 on 2003-05-01. This standard shall be read in conjunction with EN 61291-1:1998 and EN 61290-3:2000 The following dates were fixed: latest date by which the EN has to be implemented at national level by publication of an identical national standard or by endorsement (dop) 2004-02-01 latest date by which the national standards conflicting with the EN have to be withdrawn (dow) 2006-05-01 The International Electrotechnical Commission (IEC) and CENELEC draw attention to the fact that it is claimed that compliance with this International Standard/European Standard may involve the use of two patents. One patent concerns a technique for determining the amplified spontaneous emission noise of an optical amplifier in the presence of an optical signal given in clause 3 and clause 5. The IEC and CENELEC take no position concerning the evidence, validity and scope of this patent right. The holder of this patent right has assured the IEC that he/she is willing to negotiate licences under reasonable and non-discriminatory terms and conditions with applicants throughout the world. In this respect, the statement of the holder of this patent right is registered with the IEC. Information may be obtained from: Agilent Technologies Palo Alto (CA) USA Another patent concerns a measurement system and noise measurement apparatus for an optical amplifier given in clause 3 and clause 5. The IEC and CENELEC take no position concerning the evidence, validity and scope of this patent right. The holder of this patent right has assured the IEC that he/she is willing to negotiate licences under reasonable and non-discriminatory terms and conditions with applicants throughout the world. In this respect, the statement of the holder of this patent right is registered with the IEC. Information may be obtained from: Fujitsu Limited Tokyo Japan Attention is drawn to the possibility that some of the elements of this International Standard/European Standard may be the subject of patent rights other than those identified above. IEC and CENELEC shall not be held responsible for identifying any or all such patent rights. Annexes designated "normative" are part of the body of the standard. Annexes designated "informative" are given for information only. In this standard, annex ZA is normative and annexes A, B, and C are informative. Annex ZA has been added by CENELEC.
- 3 - EN 61290-10-1:2003 Endorsement notice The text of the International Standard IEC 61290-10-1:2003 was approved by CENELEC as a European Standard without any modification. In the official version, for Bibliography, the following notes have to be added for the standards indicated: IEC 60793-1 NOTE Harmonized in EN 60793-1 series (modified). IEC 60825-1 NOTE Harmonized as EN 60825-1:1994 (not modified). IEC 60825-2 NOTE Harmonized as EN 60825-2:2000 (not modified). IEC 60874-1 NOTE Harmonized as EN 60874-1:1999 (not modified). IEC 61290-1-1 NOTE Harmonized as EN 61290-1-1:1998 (not modified).
EN 61290-10-1:2003-4 - Annex ZA (normative) Normative references to international publications with their corresponding European publications This European Standard incorporates by dated or undated reference, provisions from other publications. These normative references are cited at the appropriate places in the text and the publications are listed hereafter. For dated references, subsequent amendments to or revisions of any of these publications apply to this European Standard only when incorporated in it by amendment or revision. For undated references the latest edition of the publication referred to applies (including amendments). NOTE When an international publication has been modified by common modifications, indicated by (mod), the relevant EN/HD applies. Publication Year Title EN/HD Year IEC 61290-3 - 1) Optical fibre amplifiers - Basic specification Part 3: Test methods for noise figure parameters EN 61290-3 2000 2) IEC 61291-1 - 1) Optical fibre amplifiers Part 1: Generic specification EN 61291-1 1998 2) 1) Undated reference. 2) Valid edition at date of issue.